SMOKE-FACTORY –
DATA II Operating Instructions
7 Trouble-Shooting
The DATA II does not fog
• Check external control signals
• Check mains supply
• Check fluid tank (empty?)
• Check for correct connections at the fluid bottle
• Check for fluid in the fluid tube
• Check if fluid filter is clogged
The DATA II fogs uncontrollably
• Check mains supply
• Check unit for moisture (moisture inside the machine, especially on the PCB can cause
fogging)
The DATA II
switches off suddenly
• The „Temperature cutout“ has switched off due to overheating. Remove external heat source
(for instance projector shining right onto the housing) and/or make shure sufficient fresh air
supply. After 15 to 30 minutes the unit should switch back to „on“ again.
Loud droning sound during fogging
• The pump is running dry. Avoid this absolutely!
• Refill fluid bottle
• Double check connection fluid tube and fluid bottle.
E-4 appears on the LED display
• The machine is getting too hot. The heating switches off and the machine cools down.
Solution: Disconnect the machine from the main supply for a moment and then re-connect it.
E-1/E-2/E-3 appears on the LED display
• Please send the machine to the service-station or your local dealer.
SMOKE FACTORY
issue 1.0 Page: 13 of. 15
FOG GENERATORS NEBELMASCHINEN
To Next Page
Loading...
