Need help?Do you have a question about the SMSL M300 SE and is the answer not in the manual?
General| Sampling Rate (DSD) | DSD512 |
|---|---|
| Power Supply | DC5V |
| USB Compatibility | Windows, Mac, Linux |
| Standby Power | <0.5W |
| Input Support | USB, Optical, Coaxial |
| Output Support | RCA, XLR |
| Sampling Rate (PCM) | Up to 768kHz |
| Dynamic Range | 123dB |
| THD+N | 0.0002% |
| Bit Depth | 32bit |
| DSD Sampling Rates | 2.8MHz, 5.6MHz, 11.2MHz |
| Power Consumption | <5W |
| Frequency Response | 20Hz ~ 20kHz |
| Signal-to-Noise Ratio | XLR: 128dB RCA: 123dB |
Install unit in well-ventilated area, use specified voltage, do not modify, disconnect when not in use.
Promises good quality; 7-day return/replacement, 1-year free repair.
Inappropriate use, private dismantling/repair, non-designated fittings, no proof of purchase.
New series design with tempered glass panel for high-end feel and durability.
Cirrus Logic CS43131 chip for unprecedented low distortion performance.
Supports USB, Optical, Coaxial, and Bluetooth inputs.
RCA output at 2.0Vrms and XLR output at 4.0Vrms.
Total Harmonic Distortion plus Noise (UN-WTD) is 0.00013% (-117dB).
Dynamic range (UN-WTD) is 120dB for RCA and 132dB for XLR.
Signal-to-Noise Ratio (UN-WTD) is 131dB.
Point towards receiver within 5m; avoid obstructions.
Performs a system reset by holding the knob and plugging in the USB cable.
To Next Page
