Snap-On ATECH2FM100

14
Key Beep Setup
This function will allow user to enable or disable audio feedback when a button is pressed.
1. From Settings menu, use UP   /DOWN  buttons to highlight KEY BEEP selection then press
ENTER   button.
2. KEY BEEP screen is displayed.
3. Use UP   /DOWN  buttons to highlight ENABLE (factory default) or DISABLE selection.
4. Press ENTER   button to accept selection and exit to Settings menu.
Auto Backlight Setup
This function will allow user to enable or disable backlight from turning on during torque or angle
measurement.
1. From Settings menu, use UP   /DOWN  buttons to highlight AUTO BACKLIGHT selection then
press ENTER   button.
2. AUTO BACKLIGHT screen is displayed.
3. Use UP   /DOWN  buttons to highlight ENABLE (factory default) or DISABLE selection.
4. Press ENTER   button to accept selection and exit to Settings menu.
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
EXIT
SHOW INFO
SLEEP TIME
SLEEP TIME
LCD CONTRAST
KEY BEEP
KEY BEEP
ENABLE
DISABLE
KEY BEEP
ENABLE
DISABLE
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
AUTO BACKLIGHT
ENABLE
DISABLE
AUTO BACKLIGHT
ENABLE
DISABLE