Snap-On FJ200 - TYPE OF OIL

FJ200 9 Rev. 09/09/14
MAINTENANCE
2. Check tightening of all hardware.
3. Check rotation of front wheels and rear caster
wheels.
4. Use compressed air to remove any dust or
 dirtfromthejack.    
TYPE OF OIL
In the event the jack’s hydraulic reservoir
requiresadditionaluid,useonlyanon-detergent
hydraulic jack oil with 22 viscosity rating. Using
any other uid will cause damage to the seals
and void the warranty. In order to ensure proper
performance, the correct uid level must be
maintainedinthereservoir.Theproperuidlevel
ischeckedwhenthejack’sliftarmisalltheway
down.Theuidlevelshouldbenohigherthanthe
top of the internal cylinder as shown in Figure 2.
Figure 2
FILL SCREW
FLUID LEVEL
RESERVOIR TUBE
CYLINDER