Snap-On FJ200 - MAINTENANCE; REGULARLY; WEEKLY

FJ200 8 Rev. 09/09/14
MAINTENANCE
To ensure that this jack maintains its operating
efciency, the following maintenance schedule
and procedures are required. These schedules
andproceduresaretheresponsibilityofthejack
owner.
REGULARLY - Usage and shop conditions
determine frequency.
1. Alwaysstorethejackinawellprotectedarea
where it will not be exposed to inclement
weather, corrosive vapors, abrasive dust, or
 any harmful elements. The jack must be
cleaned of water, snow, sand, grit, oil,
grease or other foreign matter
immediately after exposure.
2. Every jack owner is responsible for keeping
 jacklabelscleanandreadable.Cleaningcan
be accomplished by using a mild soap solution
to wash external surfaces but not any moving
hydraulic components. Immediately after
 cleaningdrythejackcompletely.  
3. Inspectthejackbeforeeachworkday.Donot
 use the jack if any component is cracked,
broken, bent, shows sign of damage or leaks
 hydraulic uid. Remove from service until
properly serviced or repaired.
4. Inspectthejackbeforeeachdayforlooseor
missing hardware or components. Take
corrective action before using. Premature
 wearingor damagetoanyjackcomponents
resulting from loose or missing hardware are
not eligible for warranty consideration.
WEEKLY
1. Thejackmustbelubricatedwithlithiumbase
grease (only) in order to prevent premature
wearing of parts and guarantee smooth
operation. A general purpose lithium base grease
must be used in the grease ttings provided in
both front wheels FJ200-4, lift arm assembly,
and two in the handle yoke assembly FG200-11.
Additional areas of lubrication are found in
Figure 1. Worn parts resulting from the use of
improper grease, inadequate or no lubrication are
not eligible for warranty consideration.
a. Using a grease gun, add lithium base
  greasetogreasettingintheliftarmpivot
shaft, front wheels, and handle yoke.
b. Lubricate all linkages and pivot points.
(Use white lithium spray grease only.)
c. Remove handle; lubricate handle
receptacle and handle end. (Use white
lithium spray grease only.)
d. Lubricate both rear casters bearings (Use
white lithium spray grease only.)
Figure 1
#3
#3
#1
#2
#1
#2
#4
#1