Quick Start Guide - MIG225Ai
QUICK SET-UP
1. Install a 220v electrical plug
– The Green/yellow wire is the Ground
– The Blue wire and the Brown wire are hot wires
2. Install welding wire and torch assemblies
– follow the instructions in your owner’s manual.
3. Power on using the on/off Switch in the lower back corner
– A boot up display will appear, then the home screen
4. Toggle the Torch Selection Switch to your chosen torch
– Located on the bottom of the front panel
– Right (Red) to select the aluminum push pull
– Left (Black) to select the steel / braze torch.
5. Set Up Gas Bottles with a Regulator and Adjust Gas Flow (see Pg. 3)
*You will use the Red Knob for all menu and settings selections
6. Press and Hold until you see the Main Menu (Process Parameters)
7. Click to open the Wire Selection Menu
8. Turn to scroll and highlight the kind of wire and gas you are using
9. Click to select your wire and gas
10. You will be at the Main Menu (Process Parameters) screen again.
– The Settings you selected should be at the top of the menu
11. Press and Hold to return to the Home Screen.
12. Turn to Set the Thickness of your material
– Shown in the lower right corner of the display.
13. YOU ARE NOW READY TO WELD
This welder uses a Synergic Curve Principle
* The wire speed is preset to the thickness
* The welding amps and welding voltage change as you weld
* Simply set the metal Thickness adjust the Welding Gas Flow (see Pg. 3)
To Next Page
Need help?
General
