Need help?Do you have a question about the Snap-On MM250SL and is the answer not in the manual?
General| Welding Amperage Range | 30 - 250 A |
|---|---|
| Wire Feed Speed | 50 - 700 IPM |
| Welding Process | MIG (GMAW) |
| Input Frequency | 60 Hz |
| Rated Output | 250 A at 28 VDC |
| Spool Size Capacity | 4 inch |
| Input Phase | Single Phase |
Schematic diagram for the wire feed control circuit board.
Schematic diagram for the spot time circuit board.
To Next Page
