Snap-On PLASMA30i User Manual

042011
25A PLASMA ARC CUTTING MACHINE
PLASMA30i
INTRODUCTION
The PLASMA30i is an inverter current power source machine, designed for cutting
electrically conductive materials (metals and alloys) using the plasma arc procedure. The
plasma gas may be air or nitrogen. The lightweight portable inverter plasma cutter has
many features that enable the user to easily cut most all metals.

Snap-On PLASMA30i Specifications

General

Input Frequency	50/60 Hz
Output Current	30A
Output Current Range	10-30A
Pilot Arc Starting	Yes
Input Phase	Single
Duty Cycle	60%
Weight	21.1 lb (9.6 kg)

Summary

Safety Information - Core Principles

Hazard Signal Words and Meanings

Explains DANGER, WARNING, CAUTION, IMPORTANT signal words and their meanings.

Plasma Arc Cutting Hazards and Precautions

Details hazards like UV rays, spatter, shock, heat, sparks, and vapors from plasma cutting.

Safety Information - Specific Risks

Electrical Shock and Magnetic Field Risks

Warns about electrical shock risks and magnetic field effects on medical equipment.

Explosion Hazards and Equipment Disposal

Covers explosion hazards from sparks and safe disposal of electrical equipment.

Specifications Details

Technical Specifications Summary

Key Features of the PLASMA30i

Core Features and Benefits

Installation and Start-Up Procedures

Installation Requirements and Connections

Plasma Cutting Operation Guide

Plasma Cutting Procedure Steps

Troubleshooting and Consumable Parts

Common Troubleshooting Issues

Addresses insufficient penetration and arc loss, with solutions.

Replacing Consumable Parts

Guides on replacing electrode, nozzle, swirl ring, and nozzle holder.

Maintenance Procedures and Precautions

Routine Maintenance and Cleaning