82
5-49
5-50
5-51
5-52
Operation
Reading of error code E9
If E9 is read out, at least one error was made with respect
t
o the sequence of operations when performing optimisation
(F 7.1 System messages).
— Abort the optimisation program by pressing the STOP
key and, if desired, start optimisation once again.
Fig. 5-49 OPTIMISATION “OP.12”
(4th measuring run of tyre/rim assembly)
— Clamp the wheel on the balancer.
— R
otate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
— Confi rm the valve position by pressing menu key F1.
The OPTIMISATION “OP.13” screen (Fig. 5-50) is displayed.
Fig. 5-50 OPTIMISATION “OP.13”
START is displayed on the screen.
— Press the START key.
A measuring run is performed.
The BALANCING screen (Fig. 5-51) is displayed.
Finish weight minimisation / optimisation
Fig. 5-51 BALANCING
If the wheel running conditions are optimal, the follo
wing
codes can be displayed (Fig. 5-52):
H0 Wheel running conditions cannot be improved by
optimisation.
H1 Further optimisation not recommended but feasible.
H2 Weight minimisation is recommended, optimisation can
achieve no further improvement.
To Next Page
Loading...
