Snapper 18HP, 19HP User Manual

Regular
Maintenance
16
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of
your operating time. Determining operating time is easily accomplished by observing the elapsed time recorded by
the hour meter.
SAFETY ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring &
Fall
Check Safety Interlock System
• •
Check Rider Brakes
• •
Check Mower Blade Stopping Time
• •
RIDER MAINTENANCE ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring &
Fall
Check Rider / Mower for loose hardware
•
Check / Clean Engine Cooling Fins
•
Check / Adjust PTO Clutch
*** •
Lubricate Rider & Mower **
•
Clean Battery & Cables
•
Check Tire Pressure
•
Clean Deck & Check/Replace Mower Blades**
•
Check Transmission Oil
• •
Change Transmission Oil Filter **
•
ENGINE MAINTENANCE ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring &
Fall
Check Engine Oil Level
•
Check / Change Engine Air Filter *
Change Engine Oil & Filter *
Inspect Spark Plug(s) *
Check / Replace Fuel Filter *
* Refer to engine owner’s manual. Change original engine oil after initial break-in period.
** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
*** Service after the first 25 hours of operation, then every 250 hours of operation.

Snapper 18HP, 19HP Specifications

General

Engine Power	18 HP, 19 HP
Deck Material	Steel
Transmission	Hydrostatic
Fuel Tank Capacity	3 gallons
Weight	500 lbs