Snapper 331313BE

Safety Instructions & Operator’s Manual
AUTOMATIC.BLADE STOP &
SMOOTH START CLUTCH EQUIPPED
REAR ENGINE
RIDING MOWERS
SERIES 13
MODELS
250813BE
280813BE
300813BE
281013BE
301013BE
301213BE
331313BE
331413KVE
421613BVE
Thank you for buying a SNAPPER product! Before operating your mower, read this manuai carefuiiy
and pay particuiar attention to the Important Safety Instructions on page 2. Remember that mowers
and all power equipment can be dangerous if used improperly and keep in mind that safety requires
careful use in accordance with the instructions and....common sense!
This Operator's Manual covers SERIES 13 (last two numbers in the multi-digit model designation) REAR
ENGINE RIDING MOWERS. The first two digits indicate the width of cut. The next two (or three) digits give
the horsepower rating. Models having a "B" suffix are Briggs & Stratton powered., and those with a "K" are
powered by Kohler engines. A "V" suffix is used to distinguish engines equipped with overhead valves.
Models having an "E" suffix are Electric Start.
SNAPPEH
McDonough, GA., 30253 U.S.A.
MANUAL No. 3-4145 (REV. 1,12/93)

Snapper 331313BE Specifications

General

Engine Type	Briggs & Stratton
Cutting Height Positions	7
Drive System	Rear-Wheel Drive
Speed Control	Variable Speed
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Cutting Width	21 inches
Cutting Height	1.25-3.75 inches
Wheel Size (Front)	8 inches

Summary

Critical Safety Instructions for Operation

Child Protection and Safety

Guidelines to ensure children's safety around the operating mower.

Slope Operation and Stability

Procedures for safely operating the mower on inclines to prevent tip-overs.

General Safety Precautions

Pre-Operation Checks and Engine Starting

Pre-Start Checks and Service Requirements

Essential checks, fluid levels, tire pressure, and fuel before starting.

Engine Starting Procedures

Step-by-step guide for starting the engine using electric or manual methods.

Lubrication Schedule and Points

25-Hour Lubrication Tasks

Belt Tension and Blade Brake Adjustments

Belt Tension Adjustment and Replacement

Procedures for adjusting belt tension and replacing the drive belt.

Adjusting the Blade Brake System

Steps for adjusting the blade brake for proper stopping function.

Brake, Clutch, and Blade Service Procedures

Wheel Brake System Testing and Adjustment

Cutting Blade Service and Tightening

Guide to servicing, sharpening, and securing the cutting blade.

Cutting Deck Service and Leveling

Addressing Uneven Mowing Patterns

Deck Leveling and Pitch Adjustment