Snapper 6016RT - Page 17

Wheel & Tiller Shaft Group
Footnotes:
TP 400-5131-2-RT-N
Manual No. 7006257INTERMEDIATE REAR TINE TILLER
17
Part No Descri
p
tionItem Qt
y
Note
1 1716793 1 CAP, Rear Bearing
2 1716825 1 SHIM SET, Rear Bearing Cap
2 1716826 1 SHIM, 0.062 THK1-3/4” x OD1806 (As Required)
2 1716827 1 SHIM, 0.030 THK1-3/4” x OD1807 (As Required)
2 1716828 1 SHIM, 0.015 THK1-3/4” x OD1808 (As Required)
2 1716829 1 SHIM, 0.010 THK1-3/4” x OD1809 (As Required)
3 1716810 2 BEARING, Tapered (Cone & Race)
4 1716824 4 SPACER, 1” x 1-1/4”
5 1716816 4 BUSHING
6 1716815 4 SHIM SET, Axle Spacer
6 1716817 1 SHIM, 0.062 THK1-3/8” x OD1705 (As Required)
6 1716818 1 SHIM, 0.030 THK1-3/8” x OD1706 (As Required)
6 1716819 1 SHIM, 0.015 THK1-3/8” x OD1707 (As Required)
6 1716820 1 SHIM, 0.010 THK1-3/8” x OD1708 (As Required)
7 1716830 4 RING, Snap, Internal Retainer
8 1716791 4 SEAL, Housing
9 1716821 2 RING, Snap, External Retainer
10 1722333 1 DRIVE SHAFT, Main
11 1716813 2 KEY, Parallel Plane 1/4” x 1/4” x 1”
12 1716814 1 GEAR, Worm, Wheels Shaft
13 1716811 1 SHAFT ASSEMBLY, Wheels w/Lock Pin
13 1716812 1 SHAFT ASSEMBLY, Wheel w/Lock Pin
14 1716796 1 CAP, Rear Bearing
15 1716797 1 SEAL, Oil, Drive Shaft
16 2860164 1 WASHER, 5/8
17 1716811 1 SHAFT ASSEMBLY, Wheels w/Lock Pin
18 1716823 1 GEAR, Worm Shaft