Snapper FB13250BS - Page 5

HANDLE PARTS GROUP
Footnotes:
TP 400-5009-1-CW-N
Manual No. 7006933FIELD & BRUSH MOWER
SERIES 0
5
Part No Descri
p
tionItem Qt
y
Note
1 1719965 1 GRIP, Handle
2 7058960 1 LEVER, Blade Clutch Engage (weldment) replaces 1723595
3 7027802 1 CABLE, Throttle, Kawasaki part number stamped on cable
3 7027394 1 CABLE, Throttle, Briggs part number stamped on cable
4 7014871 2 LUBE FITTING, 3/16” hole
5 7091686 2 SCREW, 1/4-20 x 3/4” Hex Washer Self-Tap
6 7029167 1 DECAL, Throttle, Brush Cutter see Decals group
7 1723550 1 BRACKET, Blade Engage Lock
8 7091318 10 SCREW, 5/16-18 x 3/4” Hex Head Cap, GR 5
9 7028200 1 SWIVEL, Adjustable, 5/16-18 thread
10 7059204 1 LEVER, Transmission Drive (weldment) replaces 1723573
11 7091601 15 NUT, 5/16-18 Hex Flange Lock, GR 5
12 7090913 2 SCREW, #10-24 x 1/2” Hex Washer Self-Tap
13 1723553 1 CONTROL DECK & DASH PANEL (weldment)
14 7091813 4 SCREW, 1/4-20 x 1-3/4 Hex Head Cap, GR 5
15 7091298 8 NUT 5/16-18 Hex Nyloc
16 7011791 3 RETAINER, 5/16” Bolt
17 7072487 1 BRACKET, Handle Pivot, RH
18 7023354 1 SWITCH, Seat NC
19 1723569 2 HANDLE, Lower
20 1723564 1 SPRING, Safety Return
21 1723561 1 WELDMENT, Safety Bar
22 7044927 1 BRACKET, Safety Bar Pivot, LH replaces 1723566
23 7033736 1 HANDLE, Upper was 1723572
24 1719968 1 COVER, Foam was 1723568
25 7090209 6 SCREW, 5/16-18 x 1” Hex Head Cap, GR 2
26 7091540 4 SCREW, 5/16-18 x 1-1/2” Hex Head Cap, GR 5
27 1723570 2 BEARING, 3/4 I.D.
28 1725232 1 WELDMENT, Drive Engagement Bar
29 1725233 1 GRIP, Reverse Handle
30 7090122 2 WASHER, 3/8 SAE Flat
31 7091518 2 NUT, 3/8-24 Hex Nyloc
32 7091294 8 WASHER, .28 x .63 x .06 Flat
33 7091310 2 HAIR PIN, #13
34 1723554 2 BALL JOINT, Type R (5/16-24 thread)
35 1723556 1 NUT, 3/8-24LH Hex Jam
36 1723557 1 BALL JOINT LH (3/8-24 LH thread)