Snapper HI-VAC 7 Series User Manual

INTRODUCTION
OPERATING PROCEDURE
This manual covers Snapper Series? walk behind 21”
push and self-propelled mowers. Series 7 models
can (with the proper attachments) discharge chop¬
ped and shredded mixed clippings (MULCHER), bag
clippings (GRASS SAG), or vacuum thatch (THAT-
CHERIZER & GRASS BAG), or vacuum clippings and
leaves (SNAPPERIZER & GRASS BAG).
The THATCH ERIZER is recommended for self-
propelled models. For more complete descriptions,
refer to the POPULAR ACCESSORIES section.
KNOW AND OBSERVE THE IMPORTANT SAFETY
INSTRUCTIONS WHEN OPERATING THE MOWER!
Know how to stop the mower in preparation for
possible emergencies BEFORE the first start-upl
For easier starting, move the mower to an area
where the blade can turn freely without being
restricted by tall grass.
The engine (and blade) is stopped by releasing the
BLADE CONTROL (7) or by pulling the ENGINE
CONTROL lever (10) rearward to the STOP posi¬
tion. On self-propelled models, releasing the WHEEL
DRIVE control (19) stops the forward movement of
the mower. Refer to FIG. 1 for locations of controls.
OPERATINQ/SERVICE POINTS
1 ADJUSTING LATCH (HEIGHT)
2 AIR BREATHER (COVER)
3 BAG
4 BAG ADAPTOR
5 BAG CONNECTOR
6 BAG WIRE SUPPORT
7 BLADE CONTROL
8 DECK
9 ENGINE
10 ENGINE CONTROL LEVER
11 FUEL FILLER CAP
12 GROUND SPEED CONTROL
13 KEY/IGNITION SWITCH
14 LOWER HANDLE
15 OIL FILLER (DIPSTICK)
16 ROPE START HANDLE
17 FUEL SHUT-OFF VALVE
18 UPPER HANDLE*
19 WHEEL DRIVE CONTROL
20 KNOB
21 DECK COVER (MULCHER)
^ FOAM GRIP ON 4 & 5 HP MODELS
FIG. 1-A-ELECTRIC START
LOCATION OF CONTROLS/FEATURES

Snapper HI-VAC 7 Series Specifications

General

Brand	Snapper
Model	HI-VAC 7 Series
Category	Lawn Mower
Language	English