EasyManuals Logo
Home>Snapper>Snow Blower>LE

Snapper LE User Manual

Snapper LE
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
PRE-OPERATION CHECKLIST for SNAPPER
SINGLE STAGE SNOW THROWERS
Complete each of the following items prior to placing the machine into service. It is very important that setup is
verified and all operational tests completed and results are acceptable. Check (
) all items actually performed.
After completing this form, sign and retain for future reference.
SET-UP (Details on Page 1 of this Instruction)
_____ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely.
_____ DISCHARGE CHUTE and DEFLECTOR ASSEMBLY installed on snow thrower.
LUBRICATION
_____ ENGINE OIL added to bring level up to full mark on 4-cycle engines (Refer to Engine Manual).
_____ OIL mixed with FUEL in specified ratio (2 Cycle Engines Only). (Refer to Engine Manual).
OPERATIONAL TEST
_____ AUGER checked to insure stopping within 5 seconds after clutch control is released.
_____ ENGINE started, engine control settings checked and adjusted as needed.
_____ FUEL SYSTEM checked for leaks around tank and connections.
_____ DISCHARGE CHUTE checked for free rotation.
_____ AUGER CONTROL CABLE adjusted per instructions in the Operator’s Manual supplied with machine.
CONSUMER INFORMATION
Purchase Date ___________________ Model _______________________ Serial No.________________________
Retailers Name ____________________________________ ______________________________________________
Address _____________________________________ City ____________________ State _______ Zip _______
MACHINE WILL BE USED COMMERCIALLY? _____ YES _____ NO
Purchaser’s Name _________________________________ Signature ____________________________________
Address ____________________________________ City _____________________ State _______ Zip _______
IMPORTANT: This form is to be retained for future reference regarding Warranty, proof of purchase, traceability
for product recall or service, etc. Complete the Snapper Product Registration Card and Mail to Customer
Service Department at SNAPPER, P.O. BOX 1379, McDonough, Georgia, 30253.
INSTRUCTION No. 2-6282 (REV.4, 4/17/01)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snapper LE and is the answer not in the manual?

Snapper LE Specifications

General IconGeneral
BrandSnapper
ModelLE
CategorySnow Blower
LanguageEnglish

Related product manuals