To Next PageTo Next Page
Need help?Do you have a question about the Snapper SMI I924E B&S 24 and is the answer not in the manual?
General| Engine | Briggs & Stratton |
|---|---|
| Fuel Type | Gasoline |
| Engine Type | 4-Cycle |
| Auger Material | Steel |
| Clearing Width | 24 inches |
Contains important safety information for operating the unit.
Provides essential safety rules and information for safe operation of the snowthrower.
Details the safety labels applied to the unit for visual reminders.
Explains the meaning of hazard symbols and signal words used in the manual and on the unit.
Explains how to find and record product identification numbers for service.
Identifies the location and basic function of various controls on the snowthrower.
Details the function of specific controls like the engine key, choke, and starter.
Covers pre-start checks and fundamental operating procedures for the snowthrower.
Lists essential checks to perform before starting the engine.
Explains the operation of electric and manual start systems and related controls.
Provides step-by-step instructions for starting the engine using electric or recoil start.
Details the procedure for safely shutting down the snowthrower engine.
Guides the user on engaging controls for auger and traction to operate the unit.
Explains how to use the speed selector for different snow conditions.
Describes how to adjust the deflector to control snow discharge distance.
Explains the adjustment of the scraper bar and skid shoes for different surfaces.
Details how to engage and disengage the traction drive lock for turning.
Provides instructions on safely clearing a blocked discharge chute.
Outlines steps to take after each use to prevent freeze-up and maintain controls.
Provides essential guidelines for safely storing the snowthrower.
Presents a schedule of required maintenance tasks and their frequencies.
Explains how to check and maintain proper tire pressure for optimal performance.
Details the procedure for checking and lubricating the auger gear case.
Provides important notes and procedures for lubricating various parts of the snowthrower.
Instructs on checking and lubricating control linkages for proper function.
Details the process for lubricating the auger shaft and assembly.
Provides solutions for common problems encountered with the snowthrower.
Addresses problems where the auger rotates but snow is not thrown or traction is poor.
Covers problems with the auger or drive not stopping, or the unit veering.
Addresses issues like difficult discharge control, excessive vibration, and speed selector problems.
Explains how to adjust the auger drive linkage for proper engagement and stopping.
Details the procedure for adjusting the traction drive cable for proper engagement.
Guides on adjusting the unit after initial hours of use for optimal performance.
Covers adjusting the auger drive belt tension and notes on traction drive belt.
Provides instructions for replacing shear pins to protect the gear box.
Explains how to adjust the belt guide for proper belt alignment.
Details the steps for replacing the auger drive belt with factory parts.
Guides on removing the rotator shaft and offset tube for belt access.
Explains how to remove the chute, rotator, and split the auger housing from the frame.
Provides detailed instructions for replacing the traction drive belt.
Lists engine make, model, torque, displacement, and oil capacity.
Details chassis dimensions, wheel size, tire pressure, and drive system.
Provides overall dimensions including clearing width, length, height, and weight.
Information on obtaining genuine Simplicity/Snapper replacement parts.
Lists convenient service and maintenance items available from the dealer.
Details how to obtain additional manuals and parts lists for the product.
