Snapper LT160H42FBV User Manual

Section 2 - OPERATING INSTRUCTIONS
2.3
STARTING & OPERATION (Continued)
2.3.2. STARTING WHEEL DRIVE
1. Shift speed control lever to neutral.
2. Start engine. Refer to Section "STARTING
ENGINE".
3. Release clutch/brake pedal.
4. Slowly shift speed control lever forward for
forward motion or to the rear for reverse motion. See
Figure 2.7.
.... REVERSE
FORWARD !
SPEEDS
FIGURE 2.7
2.3.3 STARTING MOWER BLADE
1. Start engine. Refer to Section "STARTING
ENGINE".
2. Pull blade switch OUT to engage blade. See
Figure 2.8.
PUSH BLADE SWITCH IN TO
THE ,'OFF" POSITION i
SWITCH OUT TO
THE "ON"
POSITION
FIGURE 2.8
I WARNING
DO NOT operate blades in reverse. STOP BLADES.
LOOK and SEE behind and down for children, pets
and hazards before and while backing.
2.4 STOPPING ENGINE, BLADE, WHEEL DRIVE
2.4.1 STOPPING ENGINE
1. Stop engine by turning key to the "OFF" position.
See Figure 2.9.
KEY
FIGURE 2.9
2.4.2. STOPPING WHEEL DRIVE
1. Fully depress clutch/brake pedal to stop wheel
drive. See Figure 2.10.
FULLY DEPRESS
STOP WHEEL MOTION
2
FIGURE 2.10

Snapper LT160H42FBV Specifications

General

Brand	Snapper
Model	LT160H42FBV
Category	Lawn Mower
Language	English