EasyManuals Logo

Snapper LT160H42FBV User Manual

Snapper LT160H42FBV
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section
"SERVICE - EVERY 25 OPERATING HOURS". Also
see Service Schedule.
3.4.1. ENGINE
1. Service engine according to engine owner's
manual.
3.4.2. FUEL FILTER
1. Service fuel filter as instructed below, on COLD
ENGINE ONLY!
NOTE: It may be necessary to drain the fuel tank before
removing fuel filter to prevent spillage of gasoline.
2. Locate fuel filter. Remove hose clamps and fuel
hoses from both sides of fuel filter.
3. Install new fuel filter part number 1-4359. See
Figure 3.12.
NEW FUEL FILTER
PART NUMBER 1-4359
FIGURE 3.12
4. Fill fuel tank with fresh gasoline. Refer to engine
owner's manual for fuel specifications.
3.4.3. SPARK PLUG
Remove and replace engine spark plug. Refer to
engine owner's manual for correct replacement plug
and gap specifications.
3.4.4. HYDROSTATIC TRANSMISSION OIL
The hydrostatic transmission does not require
maintenance. If any problems arise return
immediately to a Snapper dealer.
14

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snapper LT160H42FBV and is the answer not in the manual?

Snapper LT160H42FBV Specifications

General IconGeneral
BrandSnapper
ModelLT160H42FBV
CategoryLawn Mower
LanguageEnglish

Related product manuals