Snapper LT160H42FBV User Manual

Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blades running. STOP
blades. STOP engine. Set brake. Remove key.
Remove spark plug wire from spark plug and secure
wire away from spark plug. Engine and components
can be extremely hot. Avoid burns by allowing engine
and components sufficient time to cool. Wear heavy
leather gloves when handling or working around
cutting blades. Blades are extremely sharp and can
cause severe injury.
STANDARD BLADE
/
/
IGINAL CUTTING EDGE
FIGURE 4.15
4.4.2. (NINJA) BLADEWEAR LIMITS
The ninja recycling blade requires more frequent service
intervals than standard blades. Check for excessive wear
and damage before each use. See Figure 4.14.
WEAR LIMIT. (CRACKS
OR NOTCHES BEGIN
DANGEROUS
DO NOT USE ON MOWER!
FIGURE 4.14
4.4.4. (NINJA) BLADE SHARPENING
The Ninja recycling blades requires more frequent
service intervals than standard blades. When the
blades are dull, cut grass will be ragged and lawn wilt
usually turn brown. Sharpen standard blades as
follows:
1. Move tractor to a firm. level surface.
2. Turn engine "OFF". Remove key.
3. Remove mowing deck from tractor.
4. Remove mower blade(s).
5. Sharpen all cutting edges of the Ninja recycling
blade at an angle of 22 to 28 degrees for optimum
perform ance. See Figure 4.16.
F NINJA BLADE
4.4.3. (STANDARD) BLADE SHARPENING
Blades should be kept sharp at all times. When the
blades are dull, cut grass will be ragged and lawn will
usually turn brown. Sharpen standard blades as
follows:
1. Move tractor to a firm, level surface.
2. Turn engine "OFF". Remove key.
3. Remove mowing deck from tractor.
4. Remove mower blade(s).
5. If a blade is in good condition, sharpen cutting
edge at an angle of 22 to 28 degrees. DO NOT
sharpen beyond existing cutting edge. Replace blades
not in good condition. See Figure 4.15.
FIGURE 4.16
TIP
21

Snapper LT160H42FBV Specifications

General

Brand	Snapper
Model	LT160H42FBV
Category	Lawn Mower
Language	English