Snapper NZM19480KWV - Page 31

HYDRO PUMP ASSEMBLIES
Footnotes:
TP 400-5017-4-NZ-N
Manual No. 7006930MID MOUNT Z-RIDER
NZM SERIES 0 & 1
31
Part No Descri
p
tionItem Qt
y
Note
1 7075709 1 PUMP, Hydro-Gear (BDP-10A-314) Left Hand Was 74736 (used on Series 0)
-- 7075709 1 PUMP, Hydro-Gear (BDP-10A-331) Left Hand used on Series 1
2 7075710 1 PUMP, Hydro-Gear (BDP-10A-424) Right Hand Was 74737 (used on Series 0)
-- 7075710 PUMP, Hydro-Gear (BDP-10A-454) Right Hand used on Series 1
7 7059089 2 PULLEY, Hydro Drive Pump used on Series 0
-- 7075624 2 PULLEY, Hydro Drive Pump used on Series 1
8 7027199 2 KEY, M5 x M20
9 7091829 4 SCREW, 1/4-20 x 1/2” Square Head Set w/Patch Lock
10 7091627 2 WASHER, .281 x 1.00 x .125 Flat
11 7027223 2 WASHER, 1/4” Split Lock
12 7091835 2 SCREW, M6 1.0 x 12mm Hex Head Cap
13 7074738 2 HUB KIT for BDP-10A Pump w/Thru Shaft (Incl. indented items
below)
-- -- HUB, Fan Mount
-- -- WASHER, Belleville, Fan Mount
-- -- NUT, Hex Nyloc
14 7074968 2 FAN, 7” Nylon, Counter-Clockwise
15 7027181 4 BOLT, 3/8-16 x 1-1/4” Short Neck Carriage GR5
16 7013847 4 RETAINER, 3/8” Bolt
17 7090122 4 WASHER, 3/8” Flat
18 7091299 4 NUT, 3/8-16 Hex Nyloc or 76979 (3/8-16 Hex Nyloc Nut)