26
NOTICE: Do not use pressurized air or solvents to clean
-
1. Remove the fasteners (A
cover (B).
C
D).
4. Wash the pre-cleaner in liquid detergent and water.
Then allow it to thoroughly air dry. Do not oil the pre-
cleaner.
the base.
Changing the Oil Filter
For replacement intervals, see the Maintenance Chart.
1. Drain the oil from the engine. See Remove Oil sec-
tion.
A, Figure 12) and dispose of
properly.
turns.
5. Add oil. See Add Oil section.
6. Start and run the engine. As the engine warms up,
check for oil leaks.
7. Stop the engine and check the oil level. It should be at
the FULL mark on the dipstick.
Add Oil
section for oil capacity.
1. Remove the dipstick (A, Figure 4) and wipe with a
clean cloth.
C). Do not
After adding oil, wait one minute and then
check the oil level.
3. Install and tighten the dipstick.
4. Remove the dipstick and check the oil level. It should
be at the FULL mark (B) on the dipstick.
5. Install and tighten the dipstick.
Servicing the Air Filter
WARNING
explosive.
Fire or explosion can cause severe burns or
death.
To Next Page
Loading...
Need help?
General
