28
PROBLEM LOOK FOR REMEDY
Engine will not
turnover or start.
Brake pedal not
depressed.
Fully depress brake pedal.
PTO (electric clutch)
switch is in ON position.
Place in OFF position.
Cruise control engaged. Move knob to NEUTRAL/OFF position.
Out of fuel.
Disengage the choke.
Fuse is blown. See authorized dealer.
Battery terminals require
cleaning.
See Cleaning the Battery and Cables section.
Battery discharged or
dead.
Recharge or replace battery.
Wiring loose or broken. Visually check wiring. If wires are frayed or broken, see authorized
dealer.
Solenoid or starter motor
faulty.
See authorized dealer.
Safety interlock switch
faulty.
See authorized dealer.
Water in fuel. See authorized dealer.
Gas is old or stale. See authorized dealer.
Engine starts hard or
runs poorly.
Fuel mixture too rich.
Engine has other
problem.
See authorized dealer.
Engine knocks.
Low oil level. Check/add oil as required.
Using wrong grade oil. See Oil Recommendations Chart.
Excessive oil
consumption.
Engine running too hot. See authorized dealer.
Using wrong grade oil. See Oil Recommendations Chart.
Too much oil in
crankcase.
Drain excess oil.
Engine exhaust is
black.
See Servicing the Air Filter section.
Choke closed. Open choke.
Engine runs, but tractor
will not drive.
Ground speed control
pedals not depressed.
Depress pedals.
Transmission release
lever in PUSH position.
Move into DRIVE position.
Parking brake is
engaged.
Disengage parking brake.
Traction drive belt is
broken or slipping.
See authorized dealer.
Troubleshooting the Tractor
Troubleshooting
To Next Page
Loading...
Need help?
General
