Snapper SPA521 - Pump and Shelf Assemblies

PUMP AND SHELF ASSEMBLIES
Footnotes:
TP 400-5023-4-CW-N
Manual No. 7006928PRO HYDRO
SERIES 1 & 2
23
Part No Descri
p
tionItem Qt
y
Note
1 7091528 6 WASHER, 3/8” I.D. x 7/8” O.D. x 1/16” Flat
2 7091318 2 SCREW, 5/16-18 x 3/4” Hex Head Cap, GR 5
3 7029000 2 SPACER, Blade Hub
4 7028862 2 ECCENTRIC
5 7028863 2 ARM, Pump
6 7028907 4 BUSHING, Spring
7 7027127 2 HYDRAULIC PUMP
8 7027131 2 PULLEY, 5.5 w/Set Screws Includes two 1/4-20 set screws
9 7091627 2 WASHER, 1/4” Flat
10 7027223 2 WASHER, 1/4” I.D. Split Lock
11 7072893 2 SHIFT ARM, Pump
12 7091835 2 SCREW, M6 1.0 x 12mm Hex Head Cap
13 7091705 4 NUT, 1/4-20 Hex Top Lock, GR B
14 7091575 2 NUT, 5/16-18 Hex Center Lock, GR 5 or B
15 7091721 2 ROLL PIN, 5mm x 25mm
16 7091527 2 SCREW, 5/16-18 x 1-1/4” Hex Head Cap, GR 5
17 7090825 4 SCREW, 1/4-20 x 1-1/4, Hex Head Cap, GR 5
18 7027199 2 KEY, M5 x M20
19 7027181 4 BOLT, 3/8-16 x 1-1/4” Short Neck Carriage, GR 5
20 7072579 2 SPRING, Hydro
21 7077680 2 SETSCREW- 1/4-20 x 3/8” Socket Head Knurled Cup Point
22 7091315 2 WASHER, .32 x .58 x .08 Split Lock
23 7027139 2 ROD END, Pump Control Linkage (5/16-24 thread)
24 7091704 4 NUT, 3/8-16 Hex Top Lock, GR B