Snapper SPA521 - Page 41

48" & 52" MOWER DECK ASSEMBLY (Fixed Height)
Footnotes:
TP 400-5023-4-CW-N
Manual No. 7006928PRO HYDRO
SERIES 1 & 2
41
Part No Descri
p
tionItem Qt
y
Note
1 7013010 1 DECAL, Warning (CPSC Cut Finger)
2 7073647 1 DECAL, Danger Guard/Catcher
3 7023735 4 KNOB, Hood (5/16-18 thread)
4 7024156 1 DECAL, Caution- Operator Instruction
5 7027327 1 PIVOT, Roller Pin (Weldment)
6 7027344 2 WASHER, 5/8” Flat
7 7027950 1 SPRING, Chute
8 7029249 1 PULLEY, Driven, 5-3/4” O.D.
9A 7029261 1 * V-BELT, Secondary 48” (113” Long)
9B 7029266 1 * V-BELT, Secondary 52” (120” Long)
10A 7029262 1 * V-BELT, Primary 48” (66” Long)
10B 7029267 1 * V-BELT, Primary 52” (69” Long)
11 7072915 1 SPRING, Extension, Primary Idler
12 7029277 1 HINGE PIN, Chute
13 7029278 1 SPRING, Idler
14 7029281 4 STANDOFF, 4-1/2” Long (5/16-18 thread top; 3/8-16 bottom)
15 7091313 1 COTTER PIN, 3/32 x 1”
16 7046580 1 DECAL, SNAPPER Pro w/Trademark
17A 7058873 1 DEFLECTOR, 48” ANSI Compliant (Weldment)
17B 7058285 1 DEFLECTOR, 52” Euro Chute
18A 7054013 1 COVER, 48” Deck
18B 7054014 1 COVER, 52” Deck
19 7054020 2 ASSEMBLY, Caster Red (Fixed Deck) see Caster, Wheel & Tire
Assembly page
20A 7054022 1 ASSEMBLY, 48” Deck (Fixed Height) Deck weldment (7042461) plus
4 bushings (7023556)
20B 7054027 1 ASSEMBLY, 52” Deck (Fixed Height) Deck weldment (7041809) plus
4 bushings (7023556)
21 7054023 1 ASSEMBLY, Idler- 3 Spindle Deck
22 7076998 2 LUBE FITTING, 1/4-28 Straight
23 7079226 3 ROLLER, Low Density Polyethylene
24 7091299 8 NUT, 3/8-16 Hex Nyloc
25 7091304 8 BOLT, 3/8-16 x 1” Hex Head Cap, GR 5
26 7091305 2 SCREW, 3/8-16 x 2” Hex Head Cap, GR5
27 7090613 4 NUT, 3/8-16 Hex Flange Lock
28 7046626 4 BUSHING, Caster
29 7054011 3 ASSEMBLY, Spindle see Cutter Housing Assembly
Page
NOTE: * Part numbers are printed on belts.