Snapper SPA521 - Page 55

CUTTER HOUSING ASSEMBLY
Footnotes:
TP 400-5023-4-CW-N
Manual No. 7006928PRO HYDRO
SERIES 1 & 2
55
Part No Descri
p
tionItem Qt
y
Note
1 7029422 2 BEARING, Sealed
2 7029270 1 WASHER, Spindle
3 7029274 1 SNAP-RING, Spindle Shaft
4 7059311 1 ASSEMBLY, Spindle Shaft
5 7029254 1 SPACER, Bearing
6 7029271 4 SPACER, Blade
7A 7073395 3 BLADE, Commercial, 18” Low Lift for 36” (2 blades) or 52” decks
(3 blades)
7B 7073396 3 BLADE, 21” Low Lift for 61” decks; (or use 7075770,
high lift blade)
7C 7075771 3 BLADE, 16-1/2” for 48” deck
8 7016440 1 WASHER, Beveled
9 7029256 1 BOLT, 5/8-18 x 7-1/2” Hex Head Cap, GR 5
10 7029275 1 LUBE FITTING, 1/4-28 Straight (Thread Forming)
11 7029252 1 * HOUSING, Cutter
12 7029384 1 GREASE VENT, Spindle
13 7029302 6 BOLT, 3/8-16 x 1-1/4” Rib Necked
14 7029245 1 PULLEY, 5-3/4” O.D. for 48”, 52” & 61” decks
14 7029249 1 PULLEY, 5-3/4” O.D. w/Hub for 36” deck
15 7091736 1 NUT, 5/8-18 Hex Flange Lock, GR 5
16 7091299 6 NUT, 3/8-16 Hex Nyloc
17 7063238 1 ** SEAL, Nylos
18 7013370 1 ** WASHER
NOTE: * 7054017, Spindle Housing sub-assembly is made of items 11, 12 & 13.
NOTE: ** To install Bearing Pre-Seal Kit (7063240) discard item 3 & replace with items 17 & 18 as shown.