Snapper ZF2200K Safety Instructions And Operator's Manual

TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Starter Will Not Crank
Engine
1. Battery dead.
1. Service battery.
2. Blown fuse.
2. Replace fuse.
3. Electrical connections loose or corroded.
3. Clean and check connections for good contact.
4. Defective ignition switch.
4. Contact authorized SNAPPER dealer.
Engine Will Not Start 1. Blade engagement switch in the “ON" position.
1. Move blade engagement switch to “OFF”.
2. Park brake not set.
2. Set park brake.
3. Fuel tank empty.
3. Fill fuel tank with fresh fuel.
4. Engine needs choking.
4. Move choke control to “CHOKE” position.
5. Spark plug wire disconnected.
5. Place spark plug wire onto spark plug.
6. Battery weak or dead.
6. Service battery.
7. Faulty parking brake, blade or ignition switch.
7. Contact authorized SNAPPER dealer.
Engine Stalls After
Running
1. Operator not in seat.
1. Sit in operator’s seat.
2. Choke control in the “CHOKE" position.
2. Move choke control to “OFF" position.
3. Fuel tank empty.
3. Fill with engine oil to proper level.
4. Engine air pre-cleaner and or air cleaner dirty.
4. Clean free of all debris.
5. Spark plug defective or gap set improperly.
5. Service spark plug.
6. Fuel filter stopped up.
6. Replace fuel filter.
7. Water, debris or stale fuel in fuel system.
7. Drain and clean fuel system.
Engine Loses Power 1. Excessive load on engine.
1. Lessen load.
2. Engine air pre-cleaner or air cleaner dirty
2. Clean or replace filters.
3. Engine oil level low.
3. Fill with engine oil to proper level.
4. Engine cooling fins & air intake screen excessively dirty.
4. Clean cooling fins, air intake screen of all debris.
111 m ii'i ii I'lii'mi^—i
5. Service spark plug.
6. Water, debris or stale fuel in fuel system.
6. Drain and clean fuel system.
Engine Backfires When
Turned To “STOP”
1. Throttle control set too “FAST".
1. Set throttle control to “SLOW” and allow engine
to idle. Then, turn key to “OFF".
Excessive Vibration 1. Damaged or bent mower blades.
1. Service mower blade(s).
2. Loose blade components.
2. Service and tighten loose parts.
3. Loose or missing air lift (if equipped).
3. Replace air lifts. Tighten to proper torque.
O
u
18
(Trouble Shooting Continued on Next Page)

Snapper ZF2200K Specifications

General

Brand	Snapper
Model	ZF2200K
Category	Lawn Mower
Language	English