10
2. The round button below the LCD screen and to the
right (Figure 1-6, B) is the Job Timer button. While the
control is off, press and hold the Job Timer button
approximately two seconds to enter Clock-set mode. Use
the blade Raise / Lower button to toggle between 24-hour
and 12-am/pm. Use the blade Angle Left / Angle Right to
advance the edit-digit position. Use Blade Raise / Lower
to increment / decrement digit value. Advancing beyond
the “hh” digits rolls-over to Date-set mode. Press the Job
timer Button once to save and exit Clock-set mode. While
the control is on, press job timer button to start the job
timer. Press job timer button again to stop job timer. The
Control will beep once when starting the job timer and
twice when stopping it. While timer is running, square
brackets will enclose the time value. A running timer
continues to run even when the handheld control is OFF.
When the maximum displayable time of 9 hours, 59
minutes have been reached, the timer will stop. Hold Job
Timer button for approximately two seconds to reset time
value. There will be a long beep when reset.
Figure 1-6
3. The molded joystick cap in the center of the
ProControl™ transmitter (Figure 1-6, C) operates the
“Raise”, “Lower”, “Left” and “Right” functions. Pushing
joystick forward (towards the LCD screen) will “Lower”
the plow. Pulling the joystick towards the charge port if
wireless or wire if hard-wired will “Raise” the plow.
Pushing the joystick left will cause the plow to do a “Left”
function. Pushing the joystick right will cause the plow to
do a “Right” function.
4. The round button just below the joystick (Figure 1-6,
D) is the “Down Pressure” button. Pressing the button will
turn on the down pressure and a red indicator light on the
button will glow. Pressing the button again will turn the
down pressure off.
Basic Functions: V-Wing
TM
and
Revolution
TM
Plows
1. The button to the left of the joystick (Figure 1-7, E) is
the Driver’s Side Wing button. Push the button in the
area of the arrow that is closest to the LCD screen to
perform a left wing extend function. Push the button in
the opposite direction to perform a left wing retract
function.
Figure 1-7
2. The button to the right of the joystick (Figure 1-7, F) is
the Passenger’s Side Wing button. Push the button in the
area of the arrow that is closest to the LCD screen to
perform a right wing extend function. Push the button in
the opposite direction to perform a right wing retract
function.
B
C
D
E
F
To Next Page
Loading...