14
Using the ProControl
TM
to Aid in Mount-
ing and Removing the Snow Plow
The ProControl™ transmitter can be used near the snow
plow when mounting or removing the plow with the aid of
the power jackstand.
NOTE: For proper procedure in mounting and removal of
the snow plow, refer to your Sno-Way Plow Owner’s
Manual.
For Hard-Wired Units
Disconnect the cable for the ProControl™ transmitter at
the harness connection inside the vehicle cab and take
the controller to the front of the vehicle. Disconnect the
plow control harness from the vehicle control harness at
the connector at the front of the vehicle. Connect the
ProControl™ transmitter to the plow control harness. The
ProControl™ transmitter can now be used just as it is
normally used in the cab of the vehicle.
When plow mounting or removal is completed, reconnect
the ProControl™ transmitter to the vehicle harness
connector in the cab.
For Wireless Units
Remove the ProControl™ transmitter from the cab, carry
it to the front of the truck and use normally.
Storage (Hard-wired ProControl™)
Your receiver module is equipped with male and female
connectors. When power is no longer connected to the
plow, plug the male into the female connector for storage.
Your vehicle harness is also equipped with male and
female connectors. Once the plow is disconnected, plug
the male into the female connector for storage.
Wiring Schematics
ProControl™ system schematic diagrams are located in
your products Installation & Owner’s Manual.
ProControl™ Battery Warranty
The ProControl™ rechargeable battery has a 1 year
limited warranty. If Sno-Way finds that any part was
defective in material or workmanship, we will replace it
with a new battery at no charge to you. Proof of original
purchase date is required. This warranty does not cover
batteries that have been improperly installed, maintained
or repaired, or batteries that have been subject to misuse,
abuse, accident, physical damage, abnormal operation,
abnormal handling, neglect, and exposure to fire or water.
Some exclusion applies.
WARNING
When using the ProControl™ transmitter near
the plow, be especially careful of the movement
of any plow components when any switch on
the transmitter is actuated. Stand clear of the
snow plow at all times to avoid being struck by
any plow parts.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
To Next Page
Loading...