5
FCC STATEMENT OF CONDITIONS
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
OEM Responsibility to the FCC Rules and Regulations
The FreeStar Module has been certified per FCC Part 15 rules for integration into products without further
testing or certification. To fulfill the FCC certification requirements the OEM of the FreeStar Module must
ensure that the information provided on the FreeStar Label is placed on the outside of the final product.
The FreeStar Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the module
is installed inside another device, then the outside of the device into which that module is installed must
also display a label referring to the enclosed module. This exterior label can use wording such as the
following:
"Contains Transmitter Module FCC ID: TFB-FREESTAR"
or
"Contains FCC ID: TFB-FREESTAR"
The OEM of the FreeStar Module must only use the approved antenna, which has been certified with XXX
module.
The OEM of the FreeStar Module must test their final product configuration to comply with Unintentional
Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.
RF Exposure (OET Bulletin 65)
To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this transmitter should
only be used or installed at locations where there is at least 20cm separation distance between the antenna
and all persons.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation
of the device.