7
1. Ensure vehicle bumper connection is made and
vehicle supply voltage is 12VDC. Also verify that the 14
and 4 pin (when present) connectors are connected from
the receiver module to the power unit.
2. Start by putting the ProControl™ transmitter into
Pairing Mode by pressing the On and Timer buttons (two
buttons below LCD screen) simultaneously until “Paring
Remote” is displayed on transmitter LCD screen.
NOTE: Refer to "OPERATION" section for additional but-
ton details.
3. Place metal object across the 2 pin Transmitter Code
Learn contacts on the receiver module. (See Figure 1-1).
4. The ProControl™ transmitter LCD should now say
“Paired Plow”. Press the Power key once to complete the
pairing process. The ProControl™ will beep twice and
the LCD display will flash “Pairing Complete”.
NOTE: Unlike the previous generation wireless controls,
the ProControl
™
receiver module does not need to be
cleared before pairing a new transmitter. If at any time
the receiver module on wireless units is disconnected or
power is interrupted, the ProControl™ transmitter will dis-
play “lost connection” on its LCD screen.
Control Harness Installation
(Hard-Wired ProControl
TM
)
NOTE: Wireless control systems do not require the
control harness to be installed. Wireless owners may go
back to the previous section.
1. Remove the wire harness components from the bag
of harness parts included in the control package.
2. Run the 4 wire harness on the receiver unit over to the
main power harness. Zip tie where necessary to the main
power harness. Ensure the control wire harness is routed
in the power harness clamp and continue running with the
main power harness. Leave enough room to connect
harness to vehicle harness. Ensure the cable is clear of
pinch points and latching mechanism. Any excess cabling
should be kept and zip tied under the pump cover. (See
Figure 1-3a & 1-3b for 22, 26, 29/32 Series.) (See Figure
1-3c for MegaBlade Series.)
Figure 1-3a
Figure 1-3b
Figure 1-3c
NOTE: This system has no separate storage cap. It does
have a male and female connector combination that
allows for convenient storage when the plow is not in
use. Simply plug the male and female connectors
together for storage.
2. Determine a routing for the 3.7 m (12 ft.) long
harness from the vehicle bumper at the driver side of the
power pack through the vehicle engine compartment to
the cab of the vehicle.
MAIN
HARNESS
CLAMP
MAIN
HARNESS
CLAMP
MAIN
HARNESS
To Next Page
Loading...