6
Receiver Installation on Plow Power Pack
1. Loosen the fasteners holding the pump cover in place
and then lift and remove the pump cover.
2. Remove the ¼” cap screw and the ¼” nylock nut from
the top of the receiver mounting bracket.
3. With the 5-pin in-circuit programming pins positioned
on the top of the unit (See Figure 1-1), slide the receiver
module into the receiver mounting channel with the
exposed wires of the receiver box positioned toward the
hydraulic reservoir. (See Figure 1-2a for 22, 26, 29/32
Series.) (See Figure 1-2b for MegaBlade Series.)
Figure 1-1
Figure 1-2a
Figure 1-2b
4. Re-install the cap screw and nylock nut previously
removed.
5. Connect the 14 terminal connector on the receiver
module to the snow plow power pack. On MBV and MBR
Models only, also connect the four (4) terminal connector
on the receiver to the connector on the snow plow power
pack.
.
Programming Receiver to Learn
Transmitter Code
(Wireless ProControl
TM
)
NOTE: Hard-wired control systems do not require the
receiver to "learn" the transmitter code. Owners with
hard-wired controls can proceed to the next section.
Every transmitter has its own unique code. In order to
operate the plow, the receiver must "learn" the
transmitters code. The receiver will only function with a
transmitter it has been programmed for. That way several
wireless units with different transmitter codes can function
in the same area. Each receiver can "learn" one
transmitter code.
2 PIN
TRANSMITTER
CODE LEARN
5 PIN IN-CIRCUIT
PROGRAMMING
PINS
14 TERMINAL
CONNECTOR
4 TERMINAL
CONNECTOR
RECEIVER
CAP SCREW
LOCK NUT
MOUNTING
CHANNELS
CAUTION
The connectors must be plugged in correctly.
The connectors are keyed; you must line up the
slots with the tabs when plugging in the
connectors. Failure to do so WILL CAUSE
FAILURE of the receiver. When plugged in
correctly, the wire colors on each connector will
match.
RECEIVER
MOUNTING
CHANNEL
CAP SCREW
& LOCK NUT
INSTALLATION
To Next Page
Loading...