To ensure safety, remember to always disconnect the appliance from the
power supply before performing any form of maintenance or cleaning.
MAINTAINENCE
• The appliance will now start producing ice. *Time between ice making
cycles will vary depending on the ambient and water temperature.
• To change the ice bullet size, press the 'Select' button to choose
your bullet ice size preference.
• When the ice basket is full, the 'Ice' indicator light will illuminate.
You can either remove ice and store, or the ice will melt into the
water tank for water recycling.
• When the water level is low or water tank is empty, the 'Add Water'
indicator light will illuminate. You will need to add water to water tank.
INTERNAL CLEANING
• Empty the water tank using the drain plug and store the drain cap
with silicone grommet in a safe place while doing this.
• Remove the inner filter and ensure the filter is free of any debris.
SWITCHING THE APPLIANCE OFF:
• Wait for the current ice cycle to finish and press the 'Stop' button.
• Unplug the appliance from the power source.
07
• Wipe the interior dry and use a damp cloth with warm water and a mild
detergent. Avoid using any abrasive chemicals.
• Ensure that the interior is completely dry with no water inside.
• Clean the interior filter regularly (at least once a month) as well as the
'ice-full' and 'water sensors'.
DRAIN CAP WITH
SILICON GROMMET
ICE-FULL SENSOR
FILTER
WATER SENSORS
To Next Page
Loading...
