09
“Water Low” indicator
light is on
• Fill ice-maker with water and it will restart to
work automatically.
• Add a pinch of salt if using reverse osmosis water.
• Clean the water level sensor screws with ne
grit sandpaper.
“Ice Full” indicator
light is on
• Ice basket is full. Remove some ice.
• Temperature inside is too low and only deactivates if
above 10 degrees move to warmer area.
• Use lukewarm water.
The 'Ice Full' and
'Water Low' indicator
lights icker
simultaneously
• Power o the ice-maker and check the interior for
any obstructions or ice that could be blocking the ice
pusher. Restart the appliance after 3 to 5 minutes.
• While the ice-maker is turned o, recalibrate the
ice-maker by gently pushing the ice pusher into the
default resting position and then restart the
ice-maker after 3 to 5 minutes again.
• The water box motor is faulty and needs to be
repaired/replaced.
Compressor is
running but no ice
is being made
• Remove the lter and check if there is any debris
blocking the lter.
• Check if the fan is working.
• The solenoid valve needs to be replaced.
The control panel
lighting does not work
• Ensure the ice-maker is plugged in to a dedicated
power source.
• Check the interior for any obstructions or ice that could
be blocking the ice pusher. Restart the ice-maker after 3
to 5 minutes.
• The fuse on the main relay board needs to be replaced.
TROUBLESHOOTING
PROBLEM PROBLEM POSSIBLE CAUSE / MEASURE
Exterior of ice-maker
is wet
The power indicator
light is on and the
compressor is working
abnormally with a
buzzing noise
• Condensation will form on the outside of the ice-maker
if it operates in humid areas or in the rainy season,
simply wipe it dry with a non-abrasive cloth.
• The voltage is too low.
• Restart the ice-maker after 3 minutes to not damage
the compressor.
To Next Page
Loading...
