What to do if the SnoMaster SM-26 Ice Maker compressor doesn’t work?
If the compressor on your SnoMaster Ice Maker isn't working, first check if the condenser fan is running. Also, remove some ice, as the ice full light might be activated. If these steps don't resolve the issue, the compressor itself may be faulty.
Why is my SnoMaster Ice Maker not switching on?
If your SnoMaster Ice Maker isn't switching on, ensure it is correctly switched on. Check for any power outages or loadshedding in your area. Also, verify that you have followed the installation requirements correctly.
What to do if the water shortage indicator light is on in my SnoMaster SM-26?
If the water shortage indicator light is illuminated on your SnoMaster Ice Maker, examine the water supply, ensuring the inlet pipes aren't pinched and the water filter isn't blocked. If clear, restart the ice-maker. Also, verify the water pressure is between 2 and 4 bar. Check and tighten the water box nut if it's loose. A faulty water solenoid valve or a dirty water level sensor could also be the cause; the sensor may need cleaning or replacement.
What to do if fault indicator lights are on in my SnoMaster SM-26 Ice Maker?
If the fault indicator lights are illuminated on your SnoMaster Ice Maker, start by tightening the water box nut if it's loose. If that doesn't solve the problem, the water box motor, the water/evaporator sensor, or the ‘ice full’ sensor might be faulty and need replacement. Additionally, the water inlet valve or the PC board could be defective.
Why is my SnoMaster SM-26 Ice Maker compressor working, but no ice is being made?
If the compressor in your SnoMaster Ice Maker is running but no ice is being produced, there might be a refrigerant leak that requires re-gassing. Alternatively, the gas solenoid valve may need replacement, or there could be a blockage in the appliance that requires flushing and re-gassing. Ensure the condenser fan is working properly as well.
What to do if ice is not dropping or struggling to drop in my SnoMaster SM-26 Ice Maker?
If the ice in your SnoMaster Ice Maker is not dropping or is struggling to drop, check if the ambient temperature is too low (lower than 10°C) or the water temperature is too low (lower than 7°C). You may need to replace the gas solenoid valve. Also, the water/evaporator sensor could be faulty. The circulation pump could also be faulty, causing the ice to get stuck together.
Process for registering the product to ensure warranty coverage and after-sales service.
How to contact the service team for assistance or find a repair agent.
Essential precautions to prevent fire, electrical shock, or injury during use.
Detailed technical specifications of the ice maker, including dimensions, capacity, and power.
Guidelines for water connection, filtration, and cleaning to ensure optimal operation.
Step-by-step instructions for setting up the water inlet system.
Instructions on how to properly turn off the ice maker.
Procedures for cleaning the interior and exterior of the ice maker.
General| Model | SM-26 |
|---|---|
| Type | Portable Ice Maker |
| Ice Size Options | Small, Medium, Large |
| Water Reservoir Capacity | 2.2 liters |
| Ice Shape | Bullet |
| Refrigerant | R134a |
| Power Consumption | 150W |
| Material | Stainless Steel |
| Color | Silver |
| Cycle Time | 6 minutes |
| Climate Class | N |
To Next Page
