• Remove the appliance from the box and all accessories.
• Ensure the appliance is placed on a level floor for quieter operation.
• Beware that placing the appliance on a carpet may cause the heat
from the compressor to cause the carpet to fade.
• To maximize the ice-making performance of our plumbed-in
ice-makers, it’s ideal to have them in a steady environment with a
20°C ambient temperature and 10°C water temperature. While our
ice-makers can handle higher temperatures, these conditions ensure
peak production capacity.
• Avoid areas where the appliance might be exposed to direct sunlight,
any sources of heat (stove, heater, radiator, etc.), extreme hot
ambient temperatures or excessive moisture.
• Place the ice bin protector at the bottom of the ice bin and make sure
the drainage hole is not blocked, so the water can drain smoothly.
• Attach one end of the water inlet pipe to the water inlet valve on the
back of the appliance. When connecting this pipe, use the sealing
washers supplied with the ice-maker to eliminate the risk of a water
leak. The other end of the pipe should be connected to one of the
filter housing connectors.
• Connect the other water inlet pipe to the other side of the filter
housing connector. Connect the other end to a dedicated water
supply or tap. When connecting this water inlet, use the sealing
washers supplied to eliminate the risk of a water leak.
To protect the appliance from electrical surges,
it is advised to use a surge protector plug.
(Please note that this must be purchased
separately and is not supplied with the appliance.)
SURGE PROTECTOR PLUG
08
Installation of this appliance by a certified plumber is recommended
OPERATION PROCEDURE
To Next Page
