• Please unplug the appliance or disconnect the power before
performing any cleaning, maintenance, or servicing.
• If the appliance power supply cord is damaged, it must be replaced by
SnoMaster, its approved agent, or a similarly qualified person to
prevent any hazard.
• It is recommended that the circuit breaker size should be no
more than 20 amps.
• This appliance operates on a single-phase voltage of 230V/50Hz, to
avoid electrical surges, it is advised to use a surge protector plug.
• Cleaning and maintenance should be supervised by adults, especially
if children are involved.
• The appliance should be placed on a flat surface and should be
completely unobstructed. Ensure to leave 150mm space around
the appliance to ensure proper ventilation for the appliance. Place the
appliance away from direct sunlight and heat sources (stove, heater,
radiator, etc.).
• Unless specifically recommended in this manual, do not attempt to
repair or replace any part of the appliance. All other servicing should
be referred to a qualified technician.
• Never clean appliance parts with flammable fluids as they may create
a fire hazard or explosion. Also, avoid storing or using petroleum or
other flammable vapours and liquids near this appliance.
• Avoid solvent-based cleaning detergents or abrasives on the interior
or exterior as they may damage or discolour it.
• Ensure all packaging materials, stickers and films are removed from
the product. Clean the appliance’s surfaces with a mild detergent and
a damp cloth before initial use.
• Before connecting the appliance to a dedicated power source, let it
stand upright for approximately 12 hours. This measure helps
minimise the risk of cooling-system malfunctions that might occur
due to handling during incorrect transportation.
• Ensure all electrical connections are clean and dry before switching
on the appliance.
• Ensure all parts are correctly assembled before operation.
03
BEFORE USING YOUR APPLIANCE
To Next Page
Loading...
