In order to pull out the grip
easily, it is recommended to
twist the handle 90o first
and then pull it out.
Make sure the handle is
pulled out to the end position
before use, otherwise the
roll-motor will be stuck and
won’t work properly.
When you want to collapse
the gimbal，grab the top
part with one hand and
align the handle, then use
your other hand to tap
push the bottom of the
handle. Don’t put your
hands near the middle to
avoid getting pinched.
The gimbal will enter standby
mode when the tilt-axis is
collapsed to the handle, and
all the motors will stop
working. Please avoid letting
the gimbal swing over the
handle during use.
CAUTION！
To Next Page
Loading...
