AUTO CALIBRATION
Normally the gyro sensor is sensitive to the surround-
ing environment, and maybe out of balance due to
the previous transport, you can perform the auto
calibration procedure in the Snoppa App（Choose
"Drift Calibration" or "Level Calibration" in the
"Gimbal Settings" ）
Drift calibration
When the stabilizer is automatically rotating slowly, drift
calibration is needed. Before carrying out the calibration,
place the stabilizer on a surface and keep it still. The
whole process will take 1~2 minutes, make sure the
stabilizer is kept still during calibration, otherwise it can’t
get proper calibration result.
Level calibration
When finding the stabilizer is leaning to one side after
startup, level calibration is needed. Please follow the
instructions on the screen to perform the level
calibration.
To Next Page
Loading...
