Snoppa M1 - Page 8

B. With Snoppa App
Collapse the tilt-axis to the grip, quit Snoppa
app, and the gimbal will power off after 20
seconds without any operation.
Turn on the Bluetooth of the phone,
launch Snoppa App, click the Bluetooth
icon on the edge of the interface and
enter the Bluetooth setting.
Connect to SNOPPA－xxxx
Default password: 000000
To reset the password and device name, press
the button and hold for 10 seconds.
Pull out the grip, rotate the
tilt-axis of the phone until the
intersection angle is more
than 60 degree, and M1 will
start to work automatically.
60
o
Power on
Power o
Notice: Please connect the Bluetooth of the gimbal in the
Snoppa App setting panel, instead of the mobile phone’s
system setting panel.
Once connected the green light on the gimbal
will start blinking, and the Bluetooth icon will
change and dispaly the gimbal battery level.