Page 10 A38E Work Platform
Section
2.7
Machine Preparation
• When the batteries are fully charged, the charge
indicator will blink.
A CAUTION A
The batteries may be overcharged and/or
damaged if the charger is plugged in after the
charge cycle is complete. Do not leave the
battery charger on for more than 48 hours.
7. After the charge cycle is complete, unplug the
extension cord from the battery charger and
allow the batteries to cool.
8. Remove the cover on each side of the chassis
to access the batteries. Remove the caps from
each battery.
Note
Machines can also be supplied with maintenance
free batteries, uid check will not be necessary on
this type of battery.
9. Visually check the battery uid level making
sure the level is 3/8″ (10 mm) above the plates.
If needed, add distilled water.
10. Tightly replace the caps on each battery
To Next Page
Loading...
