Snorkel PRO 126 - CALIBRATION TB 120 Machines Manufactured before September 1994; Table of Contents

TABLE OF CONTENTS
SECTION I
CALIBRATION TB 120 machines manufactured before September 1994
and have not been updated to three point computers.
Joystick calibration – (lift and extend) . . . . . . . . . . . . . . . . . . . 1 - 1
Sensor calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 2
Ramp calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 2
1-3
Full speed/half speed calibration . . . . . . . . . . . . . . . . . . . . . . 1 - 3
1-4
Half speed calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 4
Valve calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 5
Backup
EMS calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 6
SECTION II
CALIBRATION TB 120 machines manufactured before September 1994
and have been updated to three point computers.
To determine if machine has been updated, look
inside turntable under base boom on right side for angle
indicator arm.
Joystick calibration – (lift and extend) . . . . . . . . . . . . . . . . . . . 2 - 1
Sensor calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 2
Three point calibration. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 2
Ramp calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
Full speed/half speed calibration . . . . . . . . . . . . . . . . . . . . . . 2 - 4
Half speed calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 5
Valve calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 6
Backup
EMS calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 7
SECTION III
CALIBRATION All PRO 100 and PRO 126 machines
and TB 120 machines manufactured after September 1994
Joystick calibration – (lift and extend) . . . . . . . . . . . . . . . . . . . 3 - 1
3-2
Sensor calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 3
3-4
Ramp calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 5
3-6
Speed calibration table (factory settings) . . . . . . . . . . . . . . . . . 3 - 6
Full speed calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 7
Half speed calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 8
Valve calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9