Quick Connect Kits Only- Once high temp nylon is measured from tank outlet to pump inlet cut tubing
using razor blade. Remove any burrs so that the fluid line properly seals against the internal o-rings
inside the quick connect fittings. Insert tubing into the quick connects until fully seated, and pull lightly
against quick connects to ensure proper installation between tank outlet to pump inlet
Step 4 Nozzle Selection
Hyper-Sonic® Nozzle Identification Chart:
Nozzle Number (Stamped On Side Of Nozzle)
Locate your Hyper-Sonic® water-methanol nozzles in the kit and compare the number stamped on the
side to the above chart to determine its size. Nozzle sizing is determined by horsepower (which
approximates the engine airflow) and boost (which approximates intake charge heat).
Determine your vehicle HP and boost/or no boost (N/A) and determine what size nozzle is needed for
your application using the nozzle selection chart below. If you are unsure what nozzle to run with your
given HP and boost send a email to tech@snowperformance.net f
or assistance.
Seal the appropriate nozzle into the nozzle holder fitting using E6000® sealant on the nozzle threads.
**The end of the nozzle with the fine mesh screen should be inserted into the nozzle holder**
**Teflon sealants are not compatible with methanol, and should not be used with the install of your Snow
Performance Boost Cooler®**
CAUTION: Pump must be shielded from road debris and direct tire wash. Failure to do so will
result in pump failure.
To Next Page
Loading...
