Snow Performance Boost Cooler - User Manual

Page | 1
Congratulations on your purchase of a Snow Performance Boost Cooler® Gas Water-Methanol
Injection kit! Keep these instructions for reference. First locate the part# of your injection system
which can be found on the front of the Boost Cooler® box. Use this number to identify which set of
electrical and setting instructions to follow.
Required Tools Needed For Install:
● Phillips/Flat Head Screwdriver
● Power Drill
● Razor Blade
● Preferred Electrical Connectors (Crimping/Stripping Tools, Blue Butts, Eye Hooks, Posi-Taps,
Fuse Taps, Soldering Supplies etc)
● Spare 16 Gauge Wire (Optional Depending On Install)
● Open End Wrench / Socket Set
● 1/8” – 27 NPT Tap (Optional Depending On Install)
Average Install Time: 4-6 Hours
www.snowperformance.net
© 2017 Snow Performance, Inc.
Locate the wiring diagram for your injection kit further in these instructions beginning on
page 8 for overview of system layout before attempting install.
CAUTION: You must completely read through these instructions before installing and operating this
product. Failure to do so can result in damage to this product and the vehicle.

Summary

Self Sealing Low Level Sensor Install

Tank Install

Pump Install

Nozzle Selection

Nozzle Mounting

Mounting for Metal and Rigid Plastic

Instructions for mounting nozzles in metal or rigid plastic using thread tape.

Mounting in Rubber Boot

Instructions for mounting nozzles in a rubber boot using a specific adapter.

High Flow Check Valve Install

Unit Wiring

Software Installation and Connection

Install Snow Platinum PC Software

Download, unzip, and install the latest Snow Platinum Software.

Connect Controller via USB

Connect the controller to the laptop using the provided USB cable.

Wiring Checkout

Verify the wiring correctness and check pump operation.

Unit Calibration

Initial Calibration Steps

Ensure ignition is off, then connect the controller and laptop.

Reading Controller Parameters

Start by clicking the Read button to ensure parameters are loaded.

MAP Sensor Calibration

Ensure MAP sensor values match the sensor for correct boost readings.

Basic Configuration Settings

Set critical parameters like Max Engine Speed, Min/Max Boost.

Settings Wizard and Tuning

Using the Settings Wizard

Utilize the wizard for setting basic configuration parameters.

Map Tuning

Fine-tune the injection map based on dyno results.

Ensuring RPM Displays Correctly

Verify RPM readings using the Pulses per Revolution field.

Final Steps and Tips

RPM Signal Configuration

Configure the pulses/revolution value for accurate RPM readings.

Final Calibration Check

Perform a final read and save the calibration file.

Installation Tips

Guidance on finding boost reference, RPM signal, and MAP sensor calibration.

Maintenance and Longevity

Cleaning Nozzles and Filters

Procedure for cleaning nozzles and screen filters using a calcium removing formula.

Electrical Connection Integrity

Ensuring tight electrical connections and using heat shrink protection.

Securing Lines and Fittings

Properly securing lines and ensuring push connect fittings seat cleanly.

Water-Meth FAQ

Tank Duration

Information on how long a 3 Qt tank lasts based on engine size.

Fluid Usage Guidelines

Guidance on suitable fluids and recommended mixture ratios.

Dyno Tuning Requirement

Discusses the necessity of custom dyno tuning with the water-meth kit.

Disclaimer and Warranty Information

Product Disclaimer

Sets forth terms and conditions for product use and acknowledges buyer's agreement.

Snow Performance 1-Year Warranty

Details the terms, conditions, and exclusions of the 1-year limited warranty.

Snow Performance Boost Cooler Specifications

General

Type	Water/Methanol Injection System
Pump Type	High-Pressure Diaphragm Pump
Benefits	Increased Horsepower, Reduced Intake Temperatures
Usage	Performance Enhancement, Engine Cooling
Installation	Requires Mechanical Skills, Includes Instructions