12
8. OPERATION
8.1 Clip onto diaper
When attaching your Snuza monitor you should put your fingers in
between the baby’s diaper and the baby’s skin. Make sure that the
monitor is clipped securely onto the diaper and away from the
baby’s skin when clipped on in order not to harm the baby.
To attach lift the front lever to release the clip. Place the clip over
the folded diaper to the full extent of the clip. Close the clip and
click the locking lever closed as shown above:-
Make sure that the Pico is close to the baby’s tummy around the
belly button area, although closer to the sides may suit different
sleeping positions.
Place on tummy for back sleepers.
Place on side of tummy for belly sleepers.
Snuza Pico has a built in alarm to indicate if the clip has been
opened while in use. Before the alarm occurs, the Snuza Pico will
beep slowly for 7 seconds to warn you to switch it off or activate
the pause function. If the clip remains open for a further 3 seconds,
the Clip Open Alarm will be activated.
8.2 Switch on/off
Snuza Pico can be turned on by briefly pressing the power button
(6) and can be switched off by pressing and holding the power
To Next Page
Loading...
Need help?
General
