2
ST-120 Mode Setting
I.
SPECIAL FEATURES:
1. One set stand alone design.
2. After installation of proximity reader and is connected to power
source, red power indicator on the front panel will light up.
3. 4 types of door opening modes:
(1) Enter 4-digit door opening password, identification code is 1.
(2) Proximity card door access, identification code is 2.
(3) Proximity card plus 4-digit door opening password ( 8
sets of 4-digit door opening passwords), identification code is 3.
(4) Proximity card or 4-digit door opening password,
identification code is 4.
4. When entering into the system setting mode, 4-digit system
password should be entered in order to enter into system setting
modes.
System code is being set at 4567 on production. In order to enter
into the system to set up mode, press
＊
# first then enter password
and press # again when completed.(Example:
＊
# 4 5 6 7 # ).
5. All proximity card or proximity key tag must be registered before
use.
6. Proximity card or proximity key tag has 8-digit number code. The
card number required for setting is the last 6 digits.
7. 8 sets of door opening passwords.
8. Maximum storage capacity of 1,000 cards.
9. Data memory feature in case of power failure.
II.
FRONT PANEL AND TYPES OF PROXIMITY CARD:
FRONT PANEL
1. Indicator lights :
(1) OK light (green) : Door open indicator light.
(2) Powe
r light (red) : System standby indicator light.
(3) External Indicator(Orange) : Activate-low
To Next Page
Loading...
