Soca ST-120 - Anti-Tamper Output Setting

8
7. Anti-tamper output setting :
This reader has an anti-tamper
output connecting point. There are two detection sources:
(1) Damage to the proximity reader(tamper switch).
(2) Damage to the door (must add detection wiring such as
reed switch).
This function can be set whether door detection point is
applied to activate the anti-tamper output:
(1) O : ON
(2) I : OFF
8. Change system password :
To change system password, this
reader’s password is being preset at 4567. Please
note that this password is necessary to enter into the system
setting mode.
PRESS ＊
TERMINATE
COMPLETED
ENTER ANTI-TAMPER
MODE 0 (ON) OR 1 (OFF)
PRESS 7
ENTER
“¿
# ” SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
1 BEEP
SOUND
1 BEEP
SOUND
PRESS ＊PRESS ＊
TERMINATETERMINATE
COMPLETED
ENTER ANTI-TAMPER
MODE 0 (ON) OR 1 (OFF)
ENTER ANTI-TAMPER
MODE 0 (ON) OR 1 (OFF)
PRESS 7PRESS 7
ENTER
“¿
# ” SYSTEM
PASSWORD “
# ”
ENTER
“¿
# ” SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
1 BEEP
SOUND
1 BEEP
SOUND
1 BEEP
SOUND
1 BEEP
SOUND
PRESS ＃
TERMINATE
ENTER THE NEW 4-DIGIT
SYSTEM PASSWORD
PRESS 8
ENTER
“¿
# ” SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
1 BEEP
SOUND
CONFIRM THE
NEW PASSWORD
PRESS ＃
1 BEEP
SOUND
2 BEEP
SOUND
PRESS ＃PRESS ＃
TERMINATETERMINATE
ENTER THE NEW 4-DIGIT
SYSTEM PASSWORD
ENTER THE NEW 4-DIGIT
SYSTEM PASSWORD
PRESS 8PRESS 8
ENTER
“¿
# ” SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
1 BEEP
SOUND
1 BEEP
SOUND
CONFIRM THE
NEW PASSWORD
PRESS ＃PRESS ＃
1 BEEP
SOUND
1 BEEP
SOUND
2 BEEP
SOUND
2 BEEP
SOUND
www.ealarm.com.my