Soca ST-120 - Setting Identification Modes; B Atch Registration

7
5.
Setting identification modes:
There are 4 sets of door-opening modes. Users could only set one of
the identification modes for access control. Its identification mode
has been preset to proximity card door-opening.
(1) Door opening based on 4-digit password (There are a total of 8
sets of user’s password), mode number is 1.
(2) Proximity card door opening, that is door will open when the
card is sensed, mode number is 2.
(3) Proximity card and enter 4-digit password door opening,
mode number is 3.
(4) Proximity card or enter 4-digit password door opening, mode
number is 4.
6.
B
atch registration :
To be used for registering multiple cards and
cards in series. Enter 6- digit card number, then enter amount of
cards, in 4-digit manner (must be in full 4 digits, such as 100 pcs. ,
enter 0100). This system can also apply to single card entry.
PRESS 5
ENTER
“½# ” SYSTEM
PASSWORD “# ”
STATUS LIGHT ON
WITH A BEEP SOUND
PRESS ＊
TERMINATE
COMPLETED
ENTER DOOR
OPENING MODE
( 1 - 4 )
1BEEP
SOUND
1BEEP
SOUND
1BEEP
SOUND
PRESS 5PRESS 5
ENTER
“½# ” SYSTEM
PASSWORD “# ”
ENTER
“½# ” SYSTEM
PASSWORD “# ”
STATUS LIGHT ON
WITH A BEEP SOUND
STATUS LIGHT ON
WITH A BEEP SOUND
PRESS ＊
TERMINATETERMINATE
COMPLETEDCOMPLETED
ENTER DOOR
OPENING MODE
( 1 - 4 )
ENTER DOOR
OPENING MODE
( 1 - 4 )
1BEEP
SOUND
1BEEP
SOUND
1BEEP
SOUND
1BEEP
SOUND
1BEEP
SOUND
1BEEP
SOUND
PRESS 6
ENTER
“½
# ”SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
ENTER FIRST
6-DIGIT CODE
ENTER QUANTITY
OF CARDS ( 4-DIGIT )
1 BEEP
SOUND
COMPLETED
BATCH
1 BEEP
SOUND
PRESS 6PRESS 6
ENTER
“½
# ”SYSTEM
PASSWORD “
# ”
STATUS LIGHT ON
WITH A BEEP SOUND
STATUS LIGHT ON
WITH A BEEP SOUND
ENTER FIRST
6-DIGIT CODE
ENTER QUANTITY
OF CARDS ( 4-DIGIT )
1 BEEP
SOUND
1 BEEP
SOUND
COMPLETED
BATCH
1 BEEP
SOUND
www.ealarm.com.my