• EN 50 082-1 – Electromagnetic Compatibility – General Immunity Standard, Part 1: Residential,
Commercial, Light Industry.
• IEC 801.2 – Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 2: Electrostatic Discharge Requirements.
• IEC 801.3 – Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 3: Radiated Electromagnetic Field Requirements.
• IEC 801.4 - Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 4: Electrical Fast Transients Requirements
LASER DEVICE:
The Socket Bluetooth Cordless Hand Scanner described in this User Guide contains a laser scan engine.
For the Class 1 version of this engine (CHS 7E and 7NRx), the following applies:
• Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007.
• Complies with IEC60825-1:2001-08
• Class 1 Laser devices are not considered to be hazardous when used for their intended purpose. The
following statement is required to comply with US and international regulations:
Caution: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
A laser warning label such as the one below appears on the battery door.
Example of Class 1 Laser Warning Label
For the Class 2 version of this engine (CHS 7M and 7P), the following applies:
• Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007.
• Complies with IEC60825-1:2001-08
• Class 2 laser scanners use a low power, visible light diode. As with any very bright light source, such
as the sun, the user should avoid staring directly into the light beam. Momentary exposure to a
Class 2 laser is not known to be harmful.
Caution: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
129
To Next Page
Loading...
