To scan barcodes:
1. Make sure the CHS is connected to the SoMo, indicated by the CHS icon in the task tray.
2. Open your application. Place the cursor where you want to enter data.
3. Press the trigger button to scan a barcode. Make sure the laser beam extends across the
entire width of the barcode.
For example, try scanning the following barcode:
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
After data is read and sent to the computer, by default, the CHS will beep once,
the LED will flash green, and the laser will turn off. The CHS 7NRx and 7P will also
vibrate to indicate that data is read. To modify the beep / LED / vibrate settings, use
the Scanner Settings utility
or Command Barcodes.
To configure an automatic Carriage Return or Tab after each scan of data, use the
Scanner Settings utility
or Command Barcodes.
If no data is read in a few seconds, the laser will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last device it paired
and connected to. Make sure your device is in range with Bluetooth enabled and
SocketScan 10 is running.
If the CHS is connected to your device and gets disconnected, it will try to reconnect for a
few minutes. Make sure the device is on and in range and SocketScan 10 is running. If the
CHS cannot reconnect, it will emit a long beep. Press the trigger button to restart the
reconnection process.
CHAPTER 4: SETUP FOR WINDOWS MOBILE 47
To Next Page
Loading...
