20
To scan barcodes:
1. In your application, place the cursor where you want to enter data.
2. Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the trigger
button. An aiming beam will appear for 3 seconds. Keep your hand steady while scanning.
For example, try scanning the following barcode:
After data is read and sent to the Apple device, by default, the CHS will beep
once and vibrate, the LED will flash green, and the beam will turn off.
If no data is read in a few seconds, the beam will turn off, and you must try
again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
After the iPad disconnects from the CHS, the soft keyboard will automatically
reappear within a few seconds.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it
paired and connected to. Make sure your computer is in range with Bluetooth
enabled.
If the CHS is connected to your computer and gets disconnected, it will try to reconnect
for 45 seconds. Make sure the computer is on and in range. If the CHS cannot
reconnect after several attempts, it will emit a long beep. Power cycle the scanner to
restart the reconnection process.
The CHS can only be paired with one device at a time. To use the CHS with a
different device, see Appendix F
for unpairing instructions.
To configure symbology support, beeps, LED, vibrate and other scanner features
use the ScannerSettings application available free on Apple App Store at:
To Next Page
Loading...
